Category Archives: brushless

3D Printing A Water Jet Drive

[Ivan Miranda] is always experimenting with 3D printing, and recently has been taking his work on the water. His latest creation is a racing paddle boat, but its performance left [Ivan] with a need for speed. Cue the development of the 3D printed water jet engine (YouTube link, embedded below). …read more

Continue reading

Posted in brushless, brushless motor, classic hacks, jet boat, water jet, water jet engine, waterjet | Leave a comment

Teardown Shows Why Innovative Designs Sometimes Fail

Some ideas are real head-scratchers from a design standpoint: Why in the world would you do it that way? For many of us, answering that question often requires a teardown, which is what [Ben Katz] did when this PCB motor-powered weed whacker came across his bench. The results are instructive on what it takes to succeed in the marketplace, or in this case, how to fail.

The unit in question comes from an outfit called CORE Outdoor Power. The line trimmer was powered by a big lithium-ion battery pack, but [Ben] concentrated on the unique motor for his teardown. After …read more

Continue reading

Posted in BLDC, brushless, flat coil, hall effect, line trimmer, pancake, pcb, rotor, staor, teardown | Leave a comment

Can You 3D-Print a Stator for a Brushless DC Motor?

Betteridge’s Law holds that any headline that ends in a question mark can be answered with a “No.” We’re not sure that [Mr. Betteridge] was exactly correct, though, since 3D-printed stators can work successfully for BLDC motors, for certain values of success.

It’s not that [GreatScott!] isn’t aware that 3D-printed motors are a thing; after all, the video below mentions the giant Halbach array motor we featured some time ago. But part of advancing the state of the art is to replicate someone else’s results, so that’s essentially what [Scott!] attempted to do here. It also builds on his recent …read more

Continue reading

Posted in BLDC, brushless, eddy currents, esc, halbach, misc hacks, permittivity, Proto-Pasta, rotor, stator, torque | Leave a comment

Using Motors As Encoders

If you have a brushless motor, you have some magnets, a bunch of coils arranged in a circle, and theoretically, all the parts you need to build a rotary encoder. A lot of people have used brushless or stepper motors as rotary encoders, but they all seem to do it by using the motor as a generator and looking at the phases and voltages. For their Hackaday Prize project, [besenyeim] is doing it differently: they’re using motors as coupled inductors, and it looks like this is a viable way to turn a motor into an encoder.

The experimental setup for …read more

Continue reading

Posted in brushless, brushless motor, encoder, rotary encoder, The Hackaday Prize | Leave a comment

Flat Pack Generators

We just wrapped up the Power Harvesting challenge in the Hackaday Prize, and with that comes some solutions to getting power in some very remote places. [Vijay]’s project is one of the best, because his project is getting power in Antarctica. This is a difficult environment: you don’t have the sun for a significant part of the year, it’s cold, and you need to actually get your equipment down to the continent. [Vijay]’s solution was to use one of Antarctica’s greatest resources — wind — in an ingenious flat pack wind turbine.

There are a few problems to harvesting wind …read more

Continue reading

Posted in brushless, brushless motor, generator, green hacks, The Hackaday Prize, Wind turbine | Leave a comment