Category Archives: control

Automatic Cut-Off Saw Takes The Tedium Out Of A Twenty-Minute Job

For [Turbo Conquering Mega Eagle], the question was simple: Do I spend 20 minutes slaving away in front of a bandsaw to cut a bunch of short brass rods into even shorter pieces of brass rod? Or do I spend days designing and building an automatic cutoff saw to do …read more

Continue reading

Posted in automation, brass, control, cut-off, metalworking, steel, tool hacks, tools | Leave a comment

Making Microfluidics Simpler With Shrinky Dinks

It’s as if the go-to analogy these days for anything technical is, “It’s like a series of tubes.” Explanations thus based work better for some things than others, and even when the comparison is apt from a physics standpoint it often breaks down in the details. With microfluidics, the analogy …read more

Continue reading

Posted in control, film, microfluidics, misc hacks, plastic, polystyrene, science, Shrink film, shrinky dinks, Tesla valve | Leave a comment

Test PCBs on a Bed of Nails

While it might be tempting to start soldering a circuit together once the design looks good on paper, experience tells us that it’s still good to test it out on a breadboard first to make sure everything works properly. That might be where the process ends for one-off projects, but for large production runs you’re going to need to test all the PCBs after they’re built, too. While you would use a breadboard for prototyping, the platform you’re going to need for quality control is called a “bed of nails“.

This project comes to us by way of [Thom] who …read more

Continue reading

Posted in bed of nails, control, driver, nixie, pins, production, prototype, quality, test, tool hacks | Leave a comment