Category Archives: Curated

Sferics, Whistlers, and the Dawn Chorus: Listening to Earth Music on VLF

We live in an electromagnetic soup, bombarded by wavelengths from DC to daylight and beyond. A lot of it is of our own making, especially further up the spectrum where wavelengths are short enough for the bandwidth needed for things like WiFi and cell phones. But long before humans figured out how to make their own electromagnetic ripples, the Earth was singing songs at the low end of the spectrum. The very low frequency (VLF) band abounds with interesting natural emissions, and listening to these Earth sounds can be quite a treat.

Long, Long Waves

The VLF band is roughly …read more

Continue reading

Posted in amateur, atmospherics, Curated, Engineering, ham, ionosphere, magnetosphere, Original Art, propagation, radio hacks, sferics, vlf | Leave a comment

This Power Strip is a Fire Starter

A few weeks ago I needed a power strip in my home office. The outlet in question is located behind a filing cabinet so it would need a low profile plug. I jumped on Amazon to buy a surge suppressor strip. That’s when I noticed strips with rotating plugs. I’ve always had some apprehensions about plugs like that, though I could never quite put my finger on why. Looking at the reviews on this particular plug, I found some scary issues. Photos of melted plugs, melted outlets, and cries of “fire hazard”. So I did what any crazy hacker would …read more

Continue reading

Posted in amazon, Belkin, burn, Curated, Featured, fire, Original Art, strip, Surge suppressor, teardown | Leave a comment

Designing for Fab: a Heads-Up before Designing PCBs for Professional Assembly

Designing pcbs for assembly is easy, right? We just squirt all the footprints onto a board layout, connect all the traces, send out the gerbers and position files, and we’re done–right?

Whoa, hold the phone, there, young rogue! Just like we can hack together some working source code with variables named after our best friends, we can also design our PCBs in ways that make it fairly difficult to assemble.

However, by following the agreed-upon design specs, we’ll put ourselves on track for success with automated assembly. If we want another party to put components on our boards, we need …read more

Continue reading

Posted in Curated, Engineering, hackaday 101, Hackaday Columns, howto, pcb, pcb assembly, PCB design, slider | Leave a comment

A Brief History of Radioactivity

More than one hundred years ago, Henri Becquerel discovered that uranium emitted penetrating rays similar to those used by Wilhelm Röntgen to take the first X-ray image (of his wife’s hand), starting a new era of far-reaching applications. There are of course many dangers that come with the use of radioactivity, but there are also many beneficial uses for our society.

WHAT IS RADIOACTIVITY

The nucleus of an atom is made of protons and neutrons. Because protons have positive charge, they repel each other, so there must be a force that holds the nucleus together, and the neutrons don’t help, …read more

Continue reading

Posted in Curated, history, nuclear, radiation, radioactivity, radioisotope, radium girls | Leave a comment

Retro Teardown: Inside An 8-Track Stereo Player

If you are a connoisseur of analogue audio, it’s probable you might have a turntable and a stack of records at home somewhere. If you are of a certain age you may even have a cassette deck, though you’re more likely to have abandoned that format some time in the 1990s. If you are old enough to have been around in the 1960s or 1970s though, you may have owned another analogue audio format. One of several that you might have found in a well-equipped home of that period was the 8-track stereo cartridge, a self-contained tape cassette format that …read more

Continue reading

Posted in audio, classic hacks, Curated, Featured, hi-fi, history, home entertainment hacks, retro, teardown | Leave a comment

Lights Out in Québec: The 1989 Geomagnetic Storm

I found myself staring up at the sky on the night of March 13, 1989, with my girlfriend and her parents in the backyard of their house. The sky was on fire, almost literally. Red and pink sheets of plasma streamed out in a circle from directly overhead, with blue-white streaks like xenon flashes occasionally strobing across the sky. We could actually hear a sizzling, crackling sound around us. The four of us stood there, awestruck by the aurora borealis we were lucky enough to witness.

At the same time, lights were winking out a couple of hundred miles north …read more

Continue reading

Posted in astronomy, Curated, Featured, geomagnetic, geomagnetic observatory, history, news, power grid, weather | Leave a comment

Tracking Index Test

In an earlier article, I covered Fire Hazard Tests that form an important part of safety testing for electronic/electrical products. We looked at the standards and equipment used for abnormal heat, glowing wire and flame tests. A typical compliance test report for an appliance, such as a toaster, will be a fairly long document reporting the results for a large number of tests. Among these, the section for “Heat and Fire” will usually have the results of a third test – Tracking. It’s a phenomena most of us have observed, but needs some explanation to understand what it means. …read more

Continue reading

Posted in ASTM, Comparative Tracking Index, CTI, Curated, Engineering, Hackaday Columns, IEC, PTI, Safety Testing, Tracking Index, UL | Leave a comment

An Introduction to Differential I²C

A few weeks back, we talked about the no-nos of running I²C over long wires. For prototyping? Yes! But for a bulletproof production environment, this practice just won’t make the cut. This month I plucked my favorite solution from the bunch and gave it a spin. Specifically, I have put together a differential I²C (DI²C) setup with the PCA9615 to talk to a string of Bosch IMUs. Behold: an IMU Noodle is born! Grab yourself a cup of coffee and join me as I arm you with the nuts and bolts of DI²C so that you too can run I²C …read more

Continue reading

Posted in BNO055, Curated, DI2C, Engineering, Featured, i2c, IMU, Skills | Leave a comment

More Power: Powel Crosley and the Cincinnati Flamethrower

We tend to think that there was a time in America when invention was a solo game. The picture of the lone entrepreneur struggling against the odds to invent the next big thing is an enduring theme, if a bit inaccurate and romanticized. Certainly many great inventions came from independent inventors, but the truth is that corporate R&D has been responsible for most of the innovations from the late nineteenth century onward. But sometimes these outfits are not soulless corporate giants. Some are founded by one inventive soul who drives the business to greatness by the power of imagination and …read more

Continue reading

Posted in amplifier, Crosley Pup, Curated, Featured, history, radio, transmitter, wlw | Leave a comment

Creating A PCB In Everything: Upverter

For the last five months, I’ve been writing a series of posts describing how to build a PCB in every piece of software out there. Every post in this series takes a reference schematic and board, and recreates all the elements in a completely new PCB tool.

There are three reasons why this sort of review is valuable. First, each post in this series is effectively a review of a particular tool. Already we’ve done Fritzing (thumbs down), KiCad (thumbs up), Eagle (thumbs up), and Protel Autotrax (interesting from a historical perspective). Secondly, each post in this series is a …read more

Continue reading

Posted in column, Creating a PCB in Everything, Curated, eda, Hackaday Columns, how-to, pcb, Skills, tutorial, upverter | Leave a comment