Category Archives: flexible PCB

Magnets Turn Flexible PCB Into Electric Grasshopper

Just because something doesn’t seem to have an apparent purpose, that doesn’t mean we shouldn’t try making it anyway. As flexible PCBs become cheaper and easier to order from low-scale fab houses, we’re seeing hobbyists experiment with new uses for them such as [Carl Bugeja]’s jumping circuit.

The circuit is …read more

Continue reading

Posted in electromagnet, flexible circuit board, flexible PCB, flexible robotics, hardware, magnets | Leave a comment

Latest FlexLED Milestone Refines the POV Display

With his FlexLED project, [Carl Bugeja] is trying to perfect a simple and affordable persistence of vision (POV) display capable of generating “holographic” characters in mid-air. Traditionally POV systems spin LEDs rapidly to create the desired illusion, but that means motors, slip rings, and noise. As the name implies, the …read more

Continue reading

Posted in flexible PCB, hologram, led, led hacks, persistence of vision, RGB LED | Leave a comment

Detecting Water Before it’s Too Late

[mcu_nerd] is like any engineer, which is why his problem of an occasionally leaky water heater sure looks like a research project with no end in sight. Sure there’s probably a commercial product out there that can be had for half the cost and a few clicks of the mouse, …read more

Continue reading

Posted in 2019 Hackaday Prize, attiny, detection, flexible PCB, home hacks, The Hackaday Prize, water | Leave a comment

New Contest: Flexible PCBs

The now-humble PCB was revolutionary when it came along, and the whole ecosystem that evolved around it has been a game changer in electronic design. But the PCB is just so… flat. Planar. Two-dimensional. As useful as it is, it gets a little dull sometimes.

Here’s your chance to break …read more

Continue reading

Posted in contest, contests, digi-key, flexible PCB, Hackaday Columns, Kapton, mechanism, oshpark, polyimide, prize, sensors, Wearables | Leave a comment

Three-Conductor Pivot for E-Textiles is Better Than Wires

Pivots for e-textiles can seem like a trivial problem. After all, wires and fabrics bend and flex just fine. However, things that are worn on a body can have trickier needs. Snap connectors are the usual way to get both an electrical connection and a pivot point, but they provide only a single conductor. When [KOBAKANT] had a need for a pivoting connection with three electrical conductors, they came up with a design that did exactly that by using a flexible circuit board integrated to a single button snap.

This interesting design is part of a solution to a specific …read more

Continue reading

Posted in copper tape, diy, e-textile, flexible PCB, hall effect, Kapton, pivot, sensor, textile, wearable, wearable hacks | Leave a comment

Flexible PCB Becomes The Actuator

An electromagnetic coil gun takes a line of electromagnets working together to form a moving electromagnetic field. These fields accelerate a project and boom, you have electricity moving matter, often at an impressive rate of speed.

[Carl Bugeja] has taken the idea and in a sense turned it upon its head with his flexible PCB actuator. Now the line of electromagnets are the moving part and the magnetic object the stationary one. There is still a line of flat PCB inductors in the classic coil gun configuration, but as the title suggests on a flexible substrate.

The result is a …read more

Continue reading

Posted in classic hacks, coil gun, flex PCB, flexible PCB, magnet, robots hacks | Leave a comment