Category Archives: hub

Printable Filament Spool Hub Skips the Bearings

When you really start fine-tuning your 3D printer, you might start to notice that even the smallest things can have a noticeable impact on your prints. An open window can cause enough of a draft to make your print peel up from the bed, and the slightly askew diameter of …read more

Continue reading

Posted in 3d Printer hacks, bearing, filament spool, hub, PLA, smooth rod | Leave a comment

Unicycle Given a Hand Crafted Gear Box

Being able to coast on a bicycle is a feature that is often taken for granted. The use of a freewheel was an improvement made early in the bicycle’s history, for obvious reasons. This also unlocked the ability to build bikes with multiple gears, allowing higher speeds to be easily reached. On a unicycle, however, there’s no chain and the pedals are permanently fixed to the wheel’s axle, meaning that there is (usually) no freewheel and no gearing. [johnybondo] wanted to get some more speed out of his unicycle, though, and realized he could do this with his own homemade …read more

Continue reading

Posted in axle, bicycle, fixed, gear, gearing, hub, Planet, ratio, transportation hacks, unicycle | Leave a comment

Wireless Doorbell Hacked Into Hands-on MQTT Tutorial

The project itself is very simple: getting push notifications via MQTT when a wireless doorbell sounds. But as [Robin Reiter] points out, as the “Hello, world!” program is a time-honored tradition for coders new to a language, so too is his project very much the hardware embodiment of the same tradition. And the accompanying video build log below is a whirlwind tour that will get the first-timer off the ground and on the way to MQTT glory.

The hardware [Robin] chose for this primer is pretty basic – a wireless doorbell consisting of a battery-powered button and a plug-in receiver …read more

Continue reading

Posted in home hacks, hub, IoT, mqtt, push, Raspberry Pi, RFDuino | Leave a comment