Category Archives: table saw

Smooth and Steady Cuts with an Improvised Power Feeder

Some woodworking operations require stock to be fed at a smooth, steady rate, for which purpose a power feeder is usually employed. They’re expensive bits of gear, though, and their cost can usually be borne only by high-output production shops. But when you need one, you need one, and hacking a power feeder from a drill and a skate wheel is a viable option.

It should come as no surprise that this woodshop hack comes to us from [Matthias Wandel], who never seems to let a woodworking challenge pass him by. His first two versions of expedient power feeders were …read more

Continue reading

Posted in BLDC, brushless, drill, lathe, machine, power feeder, table saw, tool hacks, woodshop, woodworking | Leave a comment

Adding a Riving Knife for Table Saw Safety

What in the world is a riving knife? Just the one thing that might save you from a very bad day in the shop. But if your table saw doesn’t come with one, fret not — with a little wherewithal you can add a riving knife to almost any table saw.

For those who have never experienced kickback on a table saw, we can assure you that at a minimum it will set your heart pounding. At the worst, it will suck your hand into the spinning blade and send your fingers flying, or perhaps embed a piece of wood …read more

Continue reading

Posted in Amputation, blade, kickback, riving knife, safety, sawstop, table saw, tool hacks | Leave a comment