Category Archives: TOF

Fail Of The Week: How Not To Make A 3D Scanner

Sometimes the best you can say about a project is, “Nice start.” That’s the case for this as-yet awful DIY 3D scanner, which can serve both as a launching point for further development and a lesson in what not to do.

Don’t get us wrong, we have plenty of respect for [bitluni] and for the fact that he posts his failures as well as his successes, like composite video and AM radio signals from an ESP32. He used an ESP8266 in this project, which actually uses two different sensors: an ultrasonic transducer, and a small time-of-flight laser chip. Each was …read more

Continue reading

Posted in ESP8266, Fail of the Week, JSN-SR04T, lidar, TOF, ultrasonic, VL53L0X, WebGL, wemos d1 mini | Leave a comment

xLIDAR Is A Merry-Go-Round Of Time-Of-Flight Sensors

[JRodrigo]’s xLIDAR project is one of those ideas that seemed so attractively workable that it went directly to a PCB prototype without doing much stopping along the way. The concept was to mount a trio of outward-facing VL53L0X distance sensors to a small PCB disk, and then turn that disk with a motor and belt while taking readings. As the sensors turn, their distance readings can be used to paint a picture of the immediate surroundings (at least within about 1 meter, which is the maximum range of the VL53L0X.)

The hardware is made to be accessible and has a …read more

Continue reading

Posted in distance sensor, diy, lidar, prototype, The Hackaday Prize, time of flight, TOF, VL53L0X, xlidar | Leave a comment

Touchless Shop Doors Over-Engineered to a Blissful Level

When [John Saunders] wanted an automatic door for his shop, rather than settle for a commercial unit, he designed and built a proximity-sensing opener to ease his passing. Sounds simple, right?

Fortunately for us, there are no half-measures at Saunders Machine Works, thanks to the multiple Tormach workcells and the people who know how to use them. The video below treats us to quite a build as a result; the first part is heavy on machining the many parts for the opener, so skip ahead to 8:33 if you’re more interested in the control electronics and programming.

The opener uses …read more

Continue reading

Posted in machining, misc hacks, opener, pneumatic, proximity, slide, TOF, VL53L0X | Leave a comment