Category Archives: veneer

This Method of Gluing onto Curves Sucks!

Sometimes the right tool for a job can be unusual, and this sucked only in the sense that vacuum sealing was involved. Recently [Martin Raynsford] found himself in a situation of needing to glue a wood veneer onto a curved surface, but faced a shortage of clamps. His clever solution was to vacuum-seal the whole thing and let the contour-hugging plastic bag take care of putting even pressure across the entire glued surface. After the glue had set enough to grip the materials securely, the bag was removed to let the whole thing dry completely. Gluing onto a curved surface …read more

Continue reading

Posted in clamps, curved surface, tool hacks, vacuum pack, vacuum sealer, veneer, wood, wood veneer | Leave a comment

Digital Clock Goes with the Grain

This good-looking clock appears to be made out of a block of wood with LED digits floating underneath. In reality, it is a block of PLA plastic covered with wood veneer (well, [androkavo] calls it veneer, but we think it might just be a contact paper or vinyl with a wood pattern). It makes for a striking effect, and we can think of other projects that might make use of the technique, especially since the wood surface looks much more finished than the usual 3D-printed part.

You can see a video of the clock in operation below. The clock circuit …read more

Continue reading

Posted in ARM, clock, clock hacks, dht22, ESP8266, PLA, stm32, veneer, vinyl, wood | Leave a comment